Xiamen Share nano special foam for injection molding repair, using the fourth generation of nano sponge (high density), mainly used to clean or repair the surface of molded products, is a new and safe nano-grade melamine foam.

Injection molding products and some products molded with molds often cause partial matt surface to be too smooth due to oil stains, fingerprints, small scratches and mold problems, resulting in poor appearance, usually only crushing, reheating, and increasing product costs . --How to solve?

Special sponge for injection molding repair: After wiping and repairing, the effect is good, which can greatly increase the yield rate and reduce the rework rate, saving production costs.

The special sponge for injection repair is composed of very fine particles (one ten thousandth of the hair). It has a hard texture and is suitable for grinding. It can quickly clean the handwriting/oil stains on the surface of the product; it can effectively repair small scratches; it can even frost the local smooth surface and restore the sub Light effect.

  At present, major injection molding factories and electronics factories have begun to use them in large quantities.

Innovation: Nanotechnology does not damage the surface of the object;

Convenience: Micro-grinding repair, the effect is magical.

Special sponge for injection molding repair (high-density nano-sponge), which effectively solves the defects of plastic parts such as silver streaks, flow lines, moisture and flower surface, so that the surface of the product is clean and matt. Only lower costs and simple procedures can improve production efficiency and product quality, which is your best choice.